Step 6: Reset Button
You will now be installing the mini pushbutton switch into SW4. This button is not like the others. It connects to a special circuit that sends reset signals across the board to the Propeller and LCD controller.
Tools Needed
- Soldering iron
Parts Needed
- 1 x Mini pushbutton switch
Instructions
- Find the footprint for SW4.
- Insert the mini pushbutton switch. This switch will snap into place, so no tape is needed.
- Solder the switch into place.
Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.