Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

In this part, we will add an LED that can be controlled by the LameStation, giving us our earliest signs of life for the microcontroller.

Tools Needed

  • Soldering iron
  • Cutter

Parts Needed

  • 1 x 220Ω resistor
  • 1 x green LED

Instructions

  1. Solder the 220Ω resistor into R27. This resistor sets the diode voltage for the LED we are about to add.
  2. Install the green LED into D2.
  • No labels

Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.