Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

You will be installing a 100Ω resistor to R3. This resistor controls the amount of current delivered to the LCD backlight, setting the screen's brightness.

Tools Needed

  • Soldering iron
  • Cutter

Parts Needed

  • 1 x 100Ω resistor
     

Instructions

  1. Install the 100Ω resistor in R3.
  2.  Solder and trim the leads.
  • No labels

Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.