Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

Now that everything is all good and assembled, let's put on the back pane so that no dirty fingers will be touching your LameStation.

Tools Needed

  • Phillips-head screwdriver

Parts Needed

  • 1 x Cover plate
  • 4 x Hex standoffs
  • 8 x Screws

Instructions

  • Peel the plastic off of the acrylic piece. Be careful not to put your grimy fingers on the inside of the glass, because it will stay there forever! Make sure you mount it cleanly and carefully.
  • Just like with the LCD, just screw on the standoffs on the back side.
  • Place the back piece down, being careful to orient it so that the logo is upright and the batteries are accessible.
     
  • Screw the back piece onto the standoffs, starting with opposite corners so that it's easier to position correctly.
     
  • No labels

Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.