REBOOT
Command: Reset the Propeller chip.
((PUB ┆ PRI))
REBOOT
Explanation
This is a software controlled reset, but acts like just like a hardware reset via the RESn pin.
Use REBOOT if you want to reset the Propeller chip to its power-up state. All the same hardware-based, power-up/reset delays, as well as the boot-up processes, are applied as if the Propeller had been reset via the RESn pin or a power cycle.
Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.
