You will be installing the 10kΩ resistors into R25 and R26. These resistors hold the voltage until a button is pressed.
Parts Needed
- 2 x Pushbutton switch
- 2 x 10kΩ resistor
Instructions
- Install the two 10kΩ resistors into R25 and R26 and solder them into place.
- You will be installing a pushbutton switch into SW2. Notice the flat edge on the side of the button.
- Line up this edge with the flat edge on the footprint to ensure that the button works as intended when installed into the board.
- Tape the switch down to hold in place.
- Flip the board and solder the switch into place.
- Repeat steps 2-5 to install the next pushbutton switch into footprint SW3.