...
Parts Needed
- 12 x Small 15Ω resistors
| Note | ||
|---|---|---|
| ||
If you have not done so already, remember to remove the Propeller chip, and LM386 chip before you do any soldering. We don't want to overheat them or damage them. Protect your ICs! |
Instructions
- Cut the resistors free, being careful not to bend the leads much.
- You've already noticed that these resistors are smaller than the others.
They work the same way; the LameStation uses smaller ones here to pack more of them into a tight space. Nifty, huh? - Install all the resistors into the footprints for R4-R15.
- Once they're all in, hold them all down with one of your fingers, and use a flat edge tool to bend all of the leads at once, and save yourself lots of time.
- Now have fun soldering all of these pads.
- Then trim all the leads.
- If you got them all straight, then good job, my friend. As you can see, I usually have a few that didn't go on quite right. No harm done; it will work just the same.
