...
- 12 x Small 15Ω resistors
Instructions
| Note | ||
|---|---|---|
| ||
If you have not done so already, remember to remove the Propeller chip, and LM386 chip before you do any soldering. |
- Cut the resistors free, being careful not to bend the leads much.
- You've already noticed that these resistors are smaller than the others.
They work the same way; the LameStation uses smaller ones here to pack more of them into a tight space. Nifty, huh? - Install all the resistors into the footprints for R4-R15.
- Once they're all in, hold them all down with one of your fingers, and use a flat edge tool to bend all of the leads at once, and save yourself lots of time.
- Now have fun soldering all of these pads.
- Then trim all the leads.
- If you got them all straight, then good job, my friend. As you can see, I usually have a few that didn't go on quite right. No harm done; it will work just the same.
