...
What is a regulator? What is a heatsink?
Instructions
You will be installing 3.3V and 5V regulators. You can tell them apart by reading the small print directly on the chip. The 3.3V version is pictured, and says "
3.3".Warning Read the regulators carefully!
They look almost exactly the same, but they're not! If you install them in the wrong locations, your LameStation will not work properly and it will be very time-consuming and difficult to fix.
- Find the footprint for the 3.3V regulator at U3.
- Insert the regulator.
- Slowly bend the regulator backwards so that it's flat against the board.
- Line up the regulator with the screw holes in the board, then insert a screw. It may take some wiggling to get the holes to line up.
- Thread the nut onto the screw on the other side.
- Hold the nut while gently tightening the screw with a screwdriver.
- Repeat steps 1-6 for the 5V regulator in U2.
Now that your regulators are secure against the board, solder them into place.
Tip These power pins have thicker wires, making them harder to heat up. Give the iron more time to heat up the joint.
Now you've got lots of annoying wires sticking out the back of the board. Use wire cutters (or scissors, if you can't find wire cutters).
Note Cut wires can have sharp edges. Always be careful how you are holding the LameStation during assembly.