The Iron

Tools Needed

Soldering Iron

Solder

Solder Stand

 

Sponge

Soldering Basics

Solder Joints

Not Enough Solder

Too Much Solder

If your solder joint looks like a ball, you've added too much solder. This will get harder to heat up and more likely to spill over to its neighbors.

 

Cold Solder

 

Burned Joint

 

Lifted Pad

 

Solder Bridge IMPORTANT

 

Juuuuuust Right

The perfect solder joint should be shaped like a Hershey's Kiss, but not anywhere near as delicious.

How hot is too hot?

The LameStation comes with lead-free solder, which has a higher melting point than leaded solder, so it will take more power to get it to melt.

Instructions

Don't plug in the iron until you are ready! Always unplug the iron when you are not using it.

  1. Dampen the sponge with some regular tap water.
    INSERT PICTURE OF WETTING THE SPONGE 

  2. Turn on the soldering iron. If your iron has a temperature control, you will want to set it to about 450°C for lead-free solder. Or if it doesn't, just plug it in and wait for it to heat up. This may take a couple minutes.

  3. Press the tip of the soldering iron to the wet sponge briefly. If you hear a sizzle, you know that the iron is hot.

    DO NOT touch the tip with your finger to see if it is hot! You will get burned!

  4. Melt some solder onto the tip of the iron. This is called tinning the tip. This cleans the tip and helps it to melt solder better.
     
  5. Wipe the iron against the sponge to remove any excess. You only need to do it once or twice (but do it as many times as is fun!)
     
  6. You are now ready to start soldering!

 

Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.