Step 1: The Power Switch

You will be installing the power switch. This switch opens and closes the LameStation circuit.

When the circuit is closed, electrical current can flow, so the power is turned on.

When the circuit is open, no electrical current can get through, so power is not consumed, and the device is off.

Tools Needed

  • Soldering iron

Parts Needed

  • 1 x Power switch
     

Instructions

Wait To Touch Components After Soldering Them! They will be HOT!

  1. Find the SW1 footprint, next to the power jack.
  2. Insert the sliding switch.

    Some components, like this one, won't be flush with the edge of the board; that's okay! If it fits in the footprint, and it's on the correct side of the board, you're good to go.

  3. Solder the switch into place.

Unless otherwise noted, content on this site is licensed under the
Creative Commons Attribution-ShareAlike 4.0 International License.